Power UNITS FOR LIFT TABLE 1
Standard Description
This power unit is created solely for your small lift table,Consisting of substantial strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit is broadly made use of within the marketplace of logistic products such as minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is managed by the solenoid valve together with the pace controlled by the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
General Description
This electrical power unit is designed exclusively for that medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve as well as the velocity controlled from the adjustable needle valve. When the lift rises to a large positoin, but the power supply is minimize, the decreasing movement is controlled from the manual override function.
Energy UNITS FOR LIFT TABLE three
Basic Description
This power unit is designed exclusively to the substantial lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived from the solenoid valve and also the pace managed by a strain compensated movement manage valve.
Power UNITS FOR LIFT TABLE 4
General Description
This power unit is designed solely for the massive lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and also the speed managed by the adjustable needle valve. Once the lift rises to a higher positoin, but the energy supply is lower, the reducing movement is controlled from the manual override function.
Special Notes
one. This power unit is of S3 duty cycle, which could only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean all of the hydraulic parts concerned before set up of the power unit.
3. Viscosity of the oil shoud be 15~46 cst,which need to also be clean and free of charge of impurities.N46 hydraulic oil is proposed.
4. Oil shifting is needed immediately after the initial 100 operation hours,afterwards the moment just about every 3000 hours.
5. The power unit proven is built to be mounted vertically.