SMR Gearbox Set up
Satisfactory efficiency depends on proper set up. lubrication and upkeep. hence it is necessary the guidelines during the set up and upkeep leaflet. supplied with each and every gearbox. are followed thoroughly. some of the crucial facets of belt and torque-arm installation are listed under.
1. Install pulley on gearbox input shaft as shut to your reducer doable, and mount reducer on driven shaft as near to bearing as sensible. failure to carry out this will likely trigger extra loads in the input shaft bearings and output bearings and could trigger their premature failure.
2. Install motor and wedge belt drive using the belt pull at about 90° on the center line between driven and input shafts. this will permit tensioning with the wedge belt drive using the torque arm which should preferably be in stress. if output hub runs anti-clockwise. torque arm should be positioned the correct.
three. lnstall torque-arm fulcrum on a rigid support to ensure the torque-arm are going to be at somewhere around ideal angles on the center line with the driven shaft plus the torque arm case bolt. ensure that there is certainly ample get up during the turnbuckle for belt stress adjustment.
Maintain shut.
Bell drive could be located in any convenient postion. if your torque arm would be to be used to tighten the belts, the drive need to be at about tight angle to the line in between the input and output shafts.
Bell drive may very well be found on the proper if sought after.
If output hub rotates clock-wise. position belt drive and torque arm in opposite route to that proven while in the illustration.
Torque arm and belt get up.
Torque arm could possibly be mounted on the correct if sought after.